6″ Nylon Sling D/P

6 Inch Nylon Sling D/P 150mm Wide Flat Eye Double Point Lifting Sling UAE

Six inches of flat nylon webbing spreads a load across 150mm of contact surface. That contact width is what changes the conversation on heavy precision lifts. The 6 inch nylon sling D/P carries an approximate vertical WLL of 5 tonnes with a 5:1 design factor, and the 150mm flat body distributes every tonne of that load across the full web width rather than concentrating it at a narrow strip. On large fabricated steel structures, heavy precast concrete elements, and precision-machined components where surface damage creates a rework cost, that distribution is the difference between a clean lift and a rejected component.

The webbing uses nylon polyamide in a single-ply flat construction at the full 150mm width. Nylon carries a specific mechanical advantage over polyester at this sling width: it elongates marginally under dynamic peak stress and absorbs the spike rather than transferring it directly to the crane hook, headroom hardware, and lifting points. That shock load absorption characteristic makes nylon the correct specification on fast crane picks and any lift where the load release is uneven or sudden. The flat soft eye at each end seats into standard hooks and shackles without binding or rolling in the hook throat. Every sling leaves the supply chain with a traceability label carrying WLL, serial number, manufacturer identification, and standard reference in compliance with EN 1492-1 and ASME B30.9. The non-conductive nylon body adds a safety layer on any lift near live electrical infrastructure.

Heavy module lifts on UAE offshore platforms and onshore process plants are where the 6 inch nylon sling earns its specification. A 150mm wide sling body sitting against a coated steel skid or a flanged pipe assembly distributes the full load without edge marking or coating damage. Heavy structural steel fabricators across Dubai and Sharjah use it on finished weldments and galvanised sections moving through the workshop. Port operations at Jebel Ali use the longer lengths in basket configuration on deck cargo where the wide body holds load position across the full sweep of a ship’s roll. Available in nine standard lengths from 1 metre through to 12 metres at prices from Dhs. 55 to Dhs. 144, this sling covers the full range of heavy industrial rigging tasks without requiring multiple sling types.

Sonasa Trading holds the 6 inch nylon sling D/P in stock at the Dubai warehouse with same-day dispatch on orders placed before 2PM. Wholesale lifting sling orders UAE for rigging contractors, safety supply companies, and site procurement teams receive trade pricing at volume.

 Browse the complete lifting tools collection or compare with the 5 inch nylon sling D/P if a slightly narrower body suits your load profile. Contact the Sonasa team directly on WhatsApp +971 4 2213749 for bulk order pricing and GCC delivery confirmation.

Key Features

• 6 inch (150mm) flat nylon webbing body with double-point flat soft eye at both ends, rated to approximately 5 tonnes vertical WLL with a minimum 5:1 design factor
• 150mm wide contact surface distributes load pressure across the full web width, protecting coated steel, galvanised sections, and precision-machined components from surface marking and edge damage
• Shock load absorption through nylon elongation under dynamic peak stress reduces force transfer to crane hooks, headroom hardware, and structural lifting points
• Available in nine standard lengths from 1 metre to 12 metres at Dhs. 55 to Dhs. 144, covering vertical, basket, and choker hitch configurations on a full range of heavy industrial lifts
• Supplied with traceability label carrying WLL, serial number, manufacturer reference, and EN 1492-1 standard citation meeting UAE site safety audit and equipment register requirements
• Resistant to alkalis, petroleum-based solvents, and industrial cleaning agents for sustained deployment in fabrication, oil and gas, and offshore maintenance environments
• Non-conductive nylon webbing body rated for use near live electrical installations and in confined deck and plant spaces where metallic slings carry additional hazard

Available Lengths and Pricing

Sling Length	Price (Dhs.)	Typical Application
1 Metre	Dhs. 55	Short-reach precision pick, confined space lift, fabricated component positioning
2 Metre	Dhs. 66	Standard vertical hitch, heavy precast element, large fabricated frame pick
3 Metre	Dhs. 77	Basket hitch on heavy structural steel, pipe assembly, equipment skid lift
4 Metre	Dhs. 88	Extended basket configuration, coated steel section, module pre-positioning
5 Metre	Dhs. 99	Wide load basket hitch, galvanised steel assembly, large fabricated component
6 Metre	Dhs. 110	Crane rigging on heavy civil and infrastructure sites, offshore equipment lifts
8 Metre	Dhs. 122	Large span basket hitch, deck cargo operations, vessel equipment positioning
10 Metre	Dhs. 132	Wide basket on heavy module lifts, large structural assembly, offshore supply picks
12 Metre	Dhs. 144	Maximum span heavy rigging, large civil infrastructure components, platform module lifts

In Stock at Dubai Warehouse. Same-Day Dispatch. GCC Delivery Available.

Stock held at the Sonasa Dubai warehouse. Orders placed before 2PM dispatch the same working day on a fully tracked service. GCC lifting sling delivery covers Saudi Arabia, Oman, Qatar, Kuwait, and Bahrain. Contact the Sonasa wholesale team for bulk nylon sling orders in the UAE and trade account pricing on full quantity requirements.

Safety and Certification

Standard Compliance

Every 6 inch nylon sling D/P from Sonasa Trading carries a full traceability label in accordance with EN 1492-1 and ASME B30.9 marking requirements. The label shows the rated WLL at each hitch configuration, a unique serial number, the manufacturer identification, and the applicable standard reference. That documentation satisfies the lifting equipment register and safety audit requirements across UAE construction, oil and gas, shipbuilding, and marine sectors. Riggers and appointed persons on site can confirm sling identity and rated capacity from the label without reference to an external data sheet.

INSPECTION REQUIREMENT: Inspect the full sling width before every lift. Check both faces of the 150mm body for cuts, abrasion thinning, heat glazing, and chemical discolouration. Inspect both eye seams for broken stitching and confirm the eye shape holds without distortion. Remove immediately from service if the traceability label is missing or illegible. WLL reduces at sling angles below 90 degrees to the horizontal. Apply the correct angle reduction factor before every lift.

⚠ DO NOT USE: On unprotected sharp structural edges without corner protection saddles or padding. At temperatures above 93 degrees Celsius or below minus 40 degrees Celsius. In concentrated acid environments. Never exceed the rated WLL for the hitch type and angle in use. Never use a sling with missing, damaged, or illegible identification.

Product specifications and certification references may vary between production batches. Always verify the sling label at point of use. Sonasa Trading recommends consulting your site-appointed person or lifting engineer before use in any critical, engineered, or personnel-proximity lifting application.

Technical Specifications

Specification	Details
Sling Type	Flat Eye and Eye, Double Point (D/P), Type 3 Web Sling
Web Width	6 inch (150mm)
Material	Nylon (Polyamide) synthetic webbing
Ply Construction	Single-ply flat webbing body
Eye Type	Flat soft eye both ends, opening on same plane as sling body
Approx. Vertical WLL	5 tonnes (confirm from sling label at point of use)
Approx. Basket WLL at 90 degrees	10 tonnes
Approx. Choker WLL	3.75 tonnes (75 percent of vertical)
Design Factor	5:1 minimum
Available Lengths	1m, 2m, 3m, 4m, 5m, 6m, 8m, 10m, 12m
Price Range	Dhs. 55 (1m) to Dhs. 144 (12m)
Hitch Configurations	Vertical, Basket, Choker
Operating Temperature Range	Minus 40 degrees C to plus 93 degrees C
Chemical Resistance	Resistant to alkalis and petroleum solvents. Not suitable for concentrated acid environments.
Electrical Properties	Non-conductive nylon webbing body
Compliance Reference	EN 1492-1 and ASME B30.9 synthetic sling standards
Traceability	Label with WLL, serial number, manufacturer reference, and standard citation

Applications

Heavy Construction and Civil Infrastructure

Civil works contractors across Dubai, Abu Dhabi, and the Northern Emirates use the 6 inch nylon sling D/P on large precast concrete elements including bridge beams, heavy wall panels, and staircase cores. The 150mm body sits flat against the concrete surface and spreads the pick load across the full web width. That contact area prevents the edge concentration that cracks precast units and damages architectural finishes during crane picks on high-specification civil projects.

Steel Fabrication and Structural Works

Fabrication shops handling heavy weldments, galvanised structural steelwork, and large painted assemblies use the 6 inch nylon sling to move finished components through the workshop without surface damage. A wire rope sling at the same WLL leaves compression marks and coating damage on galvanised steel. The wide nylon body distributes the contact load and the soft eye profile sits flat at the hook connection rather than rolling and marking the flange or web of the steel section it wraps.

Oil and Gas and Petrochemical Plant

Heavy maintenance scopes on UAE refineries and gas processing plants involve lifts on vessel heads, heat exchanger bundles, pump sets, and large valve assemblies where the component surface carries an epoxy coating or lining that must survive the lift intact. Wide nylon webbing slings at 150mm suit these picks because the load spreads across a surface area that a narrower sling cannot match. Resistance to petroleum solvents and alkaline cleaning agents keeps the sling serviceable in environments where chemical contact is a routine occurrence during plant maintenance operations.

Marine, Shipbuilding, and Offshore

Shipyards across the UAE and marine contractors operating offshore in the Gulf use the 6 inch lifting sling for module picks, equipment skid handling, and deck cargo operations where wide load distribution and surface protection are both requirements. The 12 metre length handles large basket configurations on deck where a short sling produces a sling angle that multiplies leg tension beyond the rated capacity. The non-conductive body suits work near electrical cable runs on vessel decks and in accommodation module installation work.

Port Operations and Heavy Logistics

Port facility operators at Jebel Ali and Khalifa Port use wide nylon web slings on crane picks involving heavy packaged machinery, transformer units, and large fabricated industrial equipment arriving on breakbulk vessels. The 5-tonne vertical WLL at 150mm width covers a significant portion of general cargo crane picks at both ports without the need for chain slings or the surface damage risk that wire rope creates on sensitive equipment finishes.